When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
New Unopened
OEMXS # KT511174
Note:This memory is for servers and workstations that require ECC Registered DRAM only and will not work in typical consumer computers. Please verify this is compatible with your board before purchasing.
ValueRAM\'s 256M x 72-bit (2GB)
DDR3-1333 CL9 SDRAM (Synchronous DRAM), registered w/
parity, 1Rx8 ECC memory module, based on nine 256M x 8-bit
DDR3-1333 FBGA components. The SPD is programmed to
JEDEC standard latency DDR3-1333 timing of 9-9-9. This 240-
pin DIMM uses gold contact fingers. The electrical and mechanical
specifications are as follows:
FEATURES
• JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
• VDDQ = 1.5V (1.425V ~ 1.575V)
• 667MHz fCK for 1333Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 9, 8, 7, 6
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• Programmable CAS Write Latency(CWL) = 7 (DDR3-1333)
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
• Bi-directional Differential Data Strobe
• Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
• On Die Termination using ODT pin
• On-DIMM thermal sensor (Grade B)
• Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
• Asynchronous Reset
• PCB : Height 1.180” (30.00mm), double sided component
N/AKVR1333D3S8R9S/2G Kingston 2GB DDR3 Registered ECC PC3-10600 1333Mhz 1Rx8 Memory
$16.50
KINGSTON 8GB PC3-10600 DIMM 1333 MHZ DDR3 SDRAM MEMORY (KVR1333D3E9S/8G) L2-2(18
$19.50
Kingston KVR1333D3S8S9/2G Memory RAM
$13.99
Documentation