Cisco WS-C2960S-48FPS-L V04 2960S 48-Port 740w POE Switch, 4x 1Gb SFP for Sale

Cisco WS-C2960S-48FPS-L V04 2960S 48-Port 740w POE Switch, 4x 1Gb SFP For Sale

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Cisco WS-C2960S-48FPS-L V04 2960S 48-Port 740w POE Switch, 4x 1Gb SFP:
$420.00

WS-C2960S-48FPS-L pulled from a working environment.

You will receive the switch, a power cable, and the rack ears with screws.

This switch has been reset to factory defaults and fully tested.

Tracking and Insurance included.

Returns accepted with 20% restock fee - buyer pays return shipping and return shipment must be tracked and insured

Please see boot sequence, show version and show inventory commands below:

Using driver version 1 for media type 1
Base ethernet MAC Address: 3c:0e:23:ea:xxxx
Xmodem file system is available.
The password-recovery mechanism is enabled.
Initializing Flash...
mifs[2]: 12 files, 1 directories
mifs[2]: Total bytes : 1806336
mifs[2]: Bytes used : 755200
mifs[2]: Bytes available : 1051136
mifs[2]: mifs fsck took 1 seconds.
mifs[3]: 0 files, 1 directories
mifs[3]: Total bytes : 3870720
mifs[3]: Bytes used : 1024
mifs[3]: Bytes available : 3869696
mifs[3]: mifs fsck took 2 seconds.
mifs[4]: 5 files, 1 directories
mifs[4]: Total bytes : 258048
mifs[4]: Bytes used : 9216
mifs[4]: Bytes available : 248832
mifs[4]: mifs fsck took 0 seconds.
mifs[5]: 5 files, 1 directories
mifs[5]: Total bytes : 258048
mifs[5]: Bytes used : 9216
mifs[5]: Bytes available : 248832
mifs[5]: mifs fsck took 0 seconds.
mifs[6]: 2 files, 1 directories
mifs[6]: Total bytes : 57931776
mifs[6]: Bytes used : 14696960
mifs[6]: Bytes available : 43234816
mifs[6]: mifs fsck took 27 seconds.
...done Initializing Flash.
done.
Loading uncompressed and installed, entry point: 0x3000
executing...

Restricted Rights Legend

Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.

cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706

Cisco IOS Software, C2960S Software (C2960S-UNIVERSALK9-M), Version 15.0(2)SE10a, RELEASE SOFTWARE (fc3)
Technical Support:
Copyright (c) 1986-2016 by Cisco Systems, Inc.
Compiled Thu 03-Nov-16 13:52 by prod_rel_teamInitializing flashfs...
Using driver version 3 for media type 1
mifs[4]: 12 files, 1 directories
mifs[4]: Total bytes : 1806336
mifs[4]: Bytes used : 755200
mifs[4]: Bytes available : 1051136
mifs[4]: mifs fsck took 0 seconds.
mifs[4]: Initialization complete.

mifs[5]: 0 files, 1 directories
mifs[5]: Total bytes : 3870720
mifs[5]: Bytes used : 1024
mifs[5]: Bytes available : 3869696
mifs[5]: mifs fsck took 0 seconds.
mifs[5]: Initialization complete.

mifs[6]: 5 files, 1 directories
mifs[6]: Total bytes : 258048
mifs[6]: Bytes used : 9216
mifs[6]: Bytes available : 248832
mifs[6]: mifs fsck took 0 seconds.
mifs[6]: Initialization complete.

mifs[7]: 5 files, 1 directories
mifs[7]: Total bytes : 258048
mifs[7]: Bytes used : 9216
mifs[7]: Bytes available : 248832
mifs[7]: mifs fsck took 0 seconds.
mifs[7]: Initialization complete.

mifs[8]: 2 files, 1 directories
mifs[8]: Total bytes : 57931776
mifs[8]: Bytes used : 14696960
mifs[8]: Bytes available : 43234816
mifs[8]: mifs fsck took 0 seconds.
mifs[8]: Initialization complete.

...done Initializing flashfs.
Checking for Bootloader upgrade..
Boot Loader upgrade not required (Stage 2)

FIPS: Flash Key Check : Begin
FIPS: Flash Key Check : End, Not Found, FIPS Mode Not Enabled

POST: MA BIST : Begin
FC 1 MBIST Test Passed.
DP Sg1 MBIST Test Passed.
DP Xg1 MBIST Test Passed.
NI 1 MBIST Test Passed.
FC 0 MBIST Test Passed.
DP Sg0 MBIST Test Passed.
DP Xg0 MBIST Test Passed.
NI 0 MBIST Test Passed.
UPB MBIST Test Passed.
POST: MA BIST : End, Status Passed

POST: TCAM BIST : Begin
POST: TCAM BIST : End, Status Passed

extracting front_end/front_end_ucode_info (86 bytes)
Waiting for Stack Master Election...
POST: Inline Power Controller Tests : Begin
POST: Inline Power Controller Tests : End, Status Passed

POST: Thermal, Fan Tests : Begin
POST: Thermal, Fan Tests : End, Status Passed

POST: PortASIC Stack Port Loopback Tests : Begin
POST: PortASIC Stack Port Loopback Tests : End, Status Passed

POST: PortASIC Port Loopback Tests : Begin
POST: PortASIC Port Loopback Tests : End, Status Passed

POST: EMAC Loopback Tests : Begin
POST: EMAC Loopback Tests : End, Status Passed

Election Complete
Switch 1 booting as Master
Waiting for Port download...Complete

This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.

A summary of U.S. laws governing Cisco cryptographic products may be found at:

If you require further assistance please contact us by sending email to

cisco WS-C2960S-48FPS-L (PowerPC) processor (revision H0) with 131072K bytes of memory.
Processor board ID FOCxxxx
Last reset from power-on
1 Virtual Ethernet interface
1 FastEthernet interface
52 Gigabit Ethernet interfaces
The password-recovery mechanism is enabled.

512K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address : 3C:0E:23:EA:xxxx
Motherboard assembly number : 73-12547-09
Power supply part number : 341-0382-02
Motherboard serial number : FOCxxxx
Power supply serial number : DCAxxxx
Model revision number : H0
Motherboard revision number : A0
Model number : WS-C2960S-48FPS-L
Daughterboard assembly number : 73-11933-04
Daughterboard serial number : FOCxxxx
System serial number : FOCxxxx
Top Assembly Part Number : 800-32647-04
Top Assembly Revision Number : C0
Version ID : V04
CLEI Code Number : COMGB00ARD
Daughterboard revision number : A0
Hardware Board Revision Number : 0x01

Switch Ports Model SW Version SW Image
------ ----- ----- ---------- ----------
* 1 52 WS-C2960S-48FPS-L 15.0(2)SE10a RETURN to get started!

*Mar 1 00:00:09.028: Read env variable - LICENSE_BOOT_LEVEL =
*Jan 2 00:00:00.503: Module name = c2960s_lanbase Next reboot level = lanbase and License = lanbase
*Jan 2 00:01:52.800: %STACKMGR-4-SWITCH_ADDED: Switch 1 has been ADDED to the stack
*Jan 2 00:01:54.153: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state to down
*Jan 2 00:01:54.153: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0, changed state to down
*Jan 2 00:01:56.910: %SPANTREE-5-EXTENDED_SYSID: Extended SysId enabled for type vlan
*Jan 2 00:01:57.267: %DC-4-FILE_OPEN_WARNING: Not able to open 2 00:01:57.267: %DC-6-DEFAULT_INIT_INFO: Default Profiles DB not loaded.
*Jan 2 00:02:22.281: %STACKMGR-5-SWITCH_READY: Switch 1 is READY
*Jan 2 00:02:22.281: %STACKMGR-4-STACK_LINK_CHANGE: Stack Port 1 Switch 1 has changed to state DOWN
*Jan 2 00:02:22.281: %STACKMGR-4-STACK_LINK_CHANGE: Stack Port 2 Switch 1 has changed to state DOWN
*Jan 2 00:02:22.511: %USB_CONSOLE-6-MEDIA_RJ45: Console media-type is RJ45.
*Jan 2 00:02:23.062: %STACKMGR-5-MASTER_READY: Master Switch 1 is READY
*Jan 2 00:02:23.450: %SYS-5-RESTART: System restarted --
Cisco IOS Software, C2960S Software (C2960S-UNIVERSALK9-M), Version 15.0(2)SE10a, RELEASE SOFTWARE (fc3)
Technical Support:
Copyright (c) 1986-2016 by Cisco Systems, Inc.
Compiled Thu 03-Nov-16 13:52 by prod_rel_team
*Jan 2 00:02:25.453: %LINK-3-UPDOWN: Interface FastEthernet0, changed state to down

--- System Configuration Dialog ---

Enable secret order to access the device manager, an enable secret is required
If you enter the initial configuration dialog, you will be prompted for the enable secret
If you choose not to enter the intial configuration dialog, or if you exit setup without setting the enable secret,
please set an enable secret using the following CLI in configuration mode-
enable secret 0 <cleartext you like to enter the initial configuration dialog? [yes/no]: ver
Cisco IOS Software, C2960S Software (C2960S-UNIVERSALK9-M), Version 15.0(2)SE10a, RELEASE SOFTWARE (fc3)
Technical Support:
Copyright (c) 1986-2016 by Cisco Systems, Inc.
Compiled Thu 03-Nov-16 13:52 by prod_rel_team

ROM: Bootstrap program is C2960S board boot loader
BOOTLDR: C2960S Boot Loader (C2960S-HBOOT-M) Version 12.2(55r)SE, RELEASE SOFTWARE (fc1)

Switch uptime is 14 minutes
System returned to ROM by power-on
System image file is product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.

A summary of U.S. laws governing Cisco cryptographic products may be found at:

If you require further assistance please contact us by sending email to

cisco WS-C2960S-48FPS-L (PowerPC) processor (revision H0) with 131072K bytes of memory.
Processor board ID FOC1748V23A
Last reset from power-on
1 Virtual Ethernet interface
1 FastEthernet interface
52 Gigabit Ethernet interfaces
The password-recovery mechanism is enabled.

Switch Ports Model SW Version SW Image
------ ----- ----- ---------- ----------
* 1 52 WS-C2960S-48FPS-L 15.0(2)SE10a register is 0xF

Switch#
Switch# sh inv
NAME: \"1\", DESCR: \"WS-C2960S-48FPS-L\"
PID: WS-C2960S-48FPS-L , VID: V04 , SN: FOCxxxx

Recent Threads

Cisco WS-C2960S-48FPS-L V04 2960S 48-Port 740w POE Switch, 4x 1Gb SFP For Sale

Cisco WS-C2960S-48FPS-L V04 2960S 48-Port 740w POE Switch, 4x 1Gb SFP: $420.00

Cisco WS-C2960S-48FPS-L V04 2960S 48-Port 740w POE Switch, 4x 1Gb SFP:
$420.00